Creating a replacement plastic

One day as I was looking over the flyer for this machine I realized I was missing a plastic over the lower pop-bumper.

There is supposed to be a matching plastic on the lower pop bumper cap (shown to the right.)


I read up online and decided to try my hand at creating one.  I found the art online, printed it on thin paper, and attached a thin piece of acrylic with clear laminate.

The graphic I was lucky enough to find online.


I then used a Dremel to cut it to shape, and sanded/polished.



Just wow – you can barely tell which is the replacement.  If I clean up the curves, it will be a perfect match!  I didn’t expect this piece to turn out so well.  I still need to permanently affix it to the bumper cap.



    • mikemikeson on December 27, 2015 at 8:23 am
    • Reply

    I was missing the piece as well, thanks to your post, I was able to rebuild.

      • Dave on December 28, 2015 at 6:03 pm
      • Reply

      Glad I could help, Enjoy!

Leave a Reply to Dave Cancel reply

Your email address will not be published.